There are no comments to view for this package. Leave a comment »
1/31/2021 1:52:35 PM Module: 150404a Version: 21 Page: 28 Comment: Bottom of page 28 second last sentence "one millionth of a meter (0.000 0001m). Should be 0.000 001m Status: Implemented
1/31/2021 1:45:45 PM Module: 150404a Version: 21 Page: 12 Comment: Page 12, graphic 12 the dial indictors should read 0.001 not 0.0001 (at least the first two). Status: Declined
1/31/2021 1:41:20 PM Module: 150404a Version: 21 Page: Comment: Graphic page 39 should have two 0.100" wear blocks to satisfy question #3 page 36. Status: Implemented
1/31/2021 1:37:41 PM Module: 150404a Version: 21 Page: 33 Comment: Page 33 figure 39 the graphic is incorrect. The angled line should be inline with the side of the triangle. Status: Implemented
1/31/2021 1:34:20 PM Module: 150404a Version: 21 Page: 17 Comment: Page 17 top of the page second sentence "Acme thread (29.5 degrees)" Should be 29 degrees. Status: Implemented
1/31/2021 1:31:03 PM Module: 150404a Version: 21 Page: 16 Comment: Page 16 third paragraph, second sentence end (0.100 / 20 = 0.002) it should equal 0.005" Status: Implemented
1/1/2019 12:00:00 AM Module: 150404a Version: 5 Page: 28 Comment: 2nd last line " one millionth of a meter (0.000 0001 m)". Has extra zero should read " (0.000 001 m)" just as it does 2 lines above for millionth of an inch. Status: Declined